![]() RigKontrol will still function as a controller (buttons, pedal) even if there is no sound going through it. Why not just connect the guitar directly to one of those inputs instead? More importantly: why should you do this anyway? This setup occupies two inputs on your 'main' soundcard. This is the expected behavior according to the general ASIO spec. selected as the I/O device in your audio application), it doesn't work - it's silent! There is no way you can route the output from it then, into the input of another card (the active one). ASIO is *much* faster, but it has a limitation in that when RigKontrol is not the active soundcard (i.e. It can work if you use WDM drivers only - but for audio work where you need realtime performance you should use ASIO, as is recommended by NI and 'everyone else'. Click to expand.I'd say this is very confusing advice.
0 Comments
Leave a Reply. |